Thermal Expansion Tanks
Have you recently receive a letter requiring the installation of a thermal control device?
County building departments and water companies across Georgia have been sending out notices to residents urging them to install thermal expansion tanks before they begin work on the local water system. This is due to a notice received by the water department from the federal government requiring water supplies to be protected against backflow. Slowly but sure all the old water meters are being updated with dual check valves and in some areas, electronic read meters.
County regulating authorities recommend the use of a thermal expansion device in conjunction with the backflow prevention devise create a closed system. A thermal expansion tank is a simple and effective method of ensuring that the water system in your home is safe and meets local code requirements.
The plumbing professionals at Michael’s Plumbing Service can install a thermal expansion tank to meet your county code requirement quickly and efficiently at an affordable price. Call us today for your appointment (770) 592-0081.
Frequently Asked Questions:
Q: What is Thermal Expansion?
A: When water is heated or cooled it expands and contracts. Thermal expansion refers to the characteristic of water to expand when it is heated . For example, water heated from 90°F to a thermostat setting of 140°F in a 40 gallon hot water heater will expand by almost one-half gallon. This is because when water is heated, its density decreases and its volume expands (see below). Since water is not compressible, the extra volume created by expansion must go someplace. During no-flow periods in a system, pressure reducing valves, backflow preventers, and other one-way valves are closed, thus eliminating a path for expanded water to flow back to the system supply. Hence, system pressure increases.
Q: When is a Thermal Expansion device necessary?
A: Thermal expansion is necessary when any of the following occurs:
Q: I have a Temperature and Pressure Relief (T&P) valve installed, isn’t that enough?
A: No. A T&P valve is not a thermal expansion control device. The T&P is designed to alleviate pressure over 150 psi, far more than the maximum allowable pressure of 80 psi limit in section 604.8 of the code.
Q: Are there any building codes with requirements for resolving thermal expansion problems?
A: Yes, section 607.3 Thermal expansion control - A means of controlling increased pressure caused by thermal expansion shall be provided where required in accordance with Sections 607.3.1 and 607.3.2.
Q: Where can I get this device?
A: Thermal expansion solutions are available at your local hardware store. A Thermal Expansion Control Device is included with your installation from Michael’s Plumbing Service.
All Services | Water Heater Main Page | Expansion Tank Repair and Installation | Cherokee County Sewer and Water Authority Expansion Tank Code | Cobb County Expansion Tank Code Requirement | Recirculating Systems | Pressure Regulating Valve Repair and Replacement | PRV Repair and Installation
Other Services We Offer:
All Services | Bathroom Plumbing | Gas Systems | Home | Kitchen Plumbing | Retail Installations | Schedule Appointment Online | Sewer and Drain | Water Heaters | Water Line Replacement and Repair | Home Care Club | Contact us